With their maximum working temperature of 300 °C and forced air circulation, the TR series ovens achieve very good temperature uniformity. They can be used for various applications such as e.g. drying, sterilising or warm storing. The stainless steel interior chamber is easy to clean and resistant to rust.
Models TR 60 to TR 240 designed as tabletop models
Models TR 420 and TR 1050 designed as floor standing models
Horizontal, forced air circulation results in temperature uniformity better than ±5 °C
Stainless steel chamber, alloy 304 (AISI)/(DIN material no. 1.4301), rust-resistant and easy to clean
Large handle to open and close the door
Charging in multiple layers possible using removeable trays (number of removeable trays included, see table below)
Large, wide-opening swing door, hinged on the right with quick release for models TR 60 to TR 420
Double swing door with quick release for TR 1050
TR 1050 equipped with transport castors
PID microprocessor control with self-diagnostic system
Infinitely adjustable exhaust at the rear wall with operation from the front
Available controller variants are the R 7 as basic variant with adjustable holding temperature or the programmable controllers B 510 (with touch panel, 5 programs with 4 segments each) and C 550 (with touch panel, 10 programs with 20 segments each)
Solid state relays provide for low noise operation
220-240 V 1/N/PE 50/60 Hz connector as standard
Option:
Over-temperature limit controller with manual reset for thermal protection class 2 in accordance with EN 60519-2 as temperature limiter to protect the furnace and load
Infinitely adjustable fan speed of the air-circulation
Window for observing charge
Further removeable grids with rails
Side inlet
Stainless steel collecting pan to protect the furnace chamber
Door hinges on the left side
Reinforced bottom plate
Safety technology according to EN 1539 for charges containing liquid solvents (TR .. LS) up to model TR 240 LS, achievable temperature uniformity ±8 °C
Transport castors for model TR 450
Upgrading available to meet the quality requirements of AMS 2750 E or FDA
Process control and documentation via VCD software package for monitoring, documentation and control
